34
HI
LOW
7. Check Before Riding
■ Pre-riding Check
Make it a habit to check the ATV before riding.
For safety reason and to prevent malfunction and an
accident from happening, it is necessary to have a
pre-riding check.
Even for a relatively simple and easy trip, a pre-riding
check is also required. If an abnormality is found, ride
your ATV to the nearest workshop or service center for
inspection and repair.
■ Oil Check and Refilling
* Oil level check
1. Start the engine and let it warm up for 2-3 minutes. Then turn off
the ignition switch for 2-3 minutes. Visually check the oil window.
2. If the oil level is at the lower limit, refill oil until the level reaches
the upper limit.
Notes:
*If the ATV is parked on a tilted surface or the engine just stops, the oil
level will not be accurate.
*When the engine stops, it is still very hot. If you check the oil level or
replace oil right after, care should be taken to avoid being burn.
To Next Page
