47
■ Changing Gear Oil
(Drain period)
For a new ATV, the drain period is one month, and then change
the gear oil every six months afterwards.
(Recommended gear oil)
SAE 90# Gear oil
Tightening torque for the draining bolt of gear oil is 2.45 kg-m
Tightening torque for the filling cap of gear oil is 2.45 kg-m
(1) Gear oil filling cap
(2) Gear oil draining bolt
Gear Oil Capacity
Full capacity: 1.0 Liter
Regular replacement volume: 0.8 Liter
How to change:
1. Start the engine and let it warm up for 2-3 minutes. Turn off the
ignition switch and remove the filling cap of gear oil.
2. Remove the draining bolt at the bottom of the engine. Turning
clockwise is to tighten the bolt, while turning counterclockwise
is to loosen the bolt. Use a container to keep the drained gear
oil.
3. After draining up gear oil, tighten the bolt again. Fill in correct
gear oil with appropriate volume.
4. Then, firmly tighten the filling cap to avoid oil seeping.
Notes:
Change gear oil more frequently under the following conditions:
* Often riding in rain
* Usually operating for long hours or long trip
* Riding under heavy load
To Next Page
