7
2. Equipment Overview
2.1 Part Description
1. Bill Guiders - Aligns the bills to be counted
2. Hopper Sensor - Senses when bills are on the hopper tray
3. Emergency Stop Button - Stops the counting operation
immediately
4. Hopper Tray - Bills are placed to be counted
5. Display/ Control Panel - Controls to operate different functions
6. Stacker Sensor - Recognizes when a bill is on the stacker
7. Stacker Tray - Location of counted bills
8. Carry handle - Used to carry and transport the equipment
9. Feeding Gap Adjustment Knob - Used to adjust the opening
where bills enter
10. Serial 1 port - Install Updates/ Technical Service
11. Serial 2 port - Auxiliary Display connection
12. USB port - Install Updates/ Technical Service
13. On / Off switch - Used to tum the equipment on and off
14. Power Jack - Connection for the power cord
To Next Page
Loading...
