9
2. Equipment Overview (continued)
2.2 Control Panel Description (continued)
• UV: Ultraviolet Verification On/Off (UV and MG/UV model only)
This function allows the equipment to analyze the ultraviolet
characteristics of each bill while counting. The equipment will stop
counting if a bill is considered suspicious. The UV sensitivity can be
adjusted from 1-9, where 1 is the minimum and 9 is the maximum
sensitivity.
• DD: Bill Size Verification (Width) On/Off
This function allows the equipment to analyze the width of each bill
while counting. The equipment will stop counting if a bill with a different
size is found. The DD sensitivity can be adjusted from 1-9, where 1 is the
minimum and 9 is the maximum sensitivity.
• LEVEL: This allows the adjustment of the emission intensity of the
counting sensors. It can be adjusted from 1-9, where 1 is the minimum
and 9 is the maximum.
• C key: Used to clear (delete) the counted data from the display
• BATCH: Preset batch selection
By pressing the BATCH key repeatedly, the preset batch value will
change among 5, 10, 20, 25, 50, 100, 200, or off.
• START: While in MANUAL mode, used to Start or Stop the count. Also
used to accept and confirm batch selection as well as security functions
sensitivities.
• Numeric Keys: Used to set up batch sizes manually and to enter the
value for security function sensitivity levels.
To Next Page
Loading...
