16
4. Operation
4.1 Counting Operation
- Proceed to turn the unit ON.
- The unit will proceed with a short Self-Test routine to confirm the proper
operation of all its modules before starting the count. If any error is
reported, check the ERROR MESSAGES section for a solution to the
problem.
- Select the desired verification functions to use (MG-UV-DD etc.) based
on the security features of your currency.
- Set up the rest of the options like SPEED, BATCH, etc. based on your
own needs.
- Place the bills orderly in the hopper and the unit will start counting them
automatically.
NOTE: If the unit is set to MANUAL, press START to begin the counting
operation.
4.2 Miscounting errors
In case the unit is not having an accurate counting operation, proceed as
follow:
- Ensure that the banknotes are placed orderly in the hopper.
- Check the counting sensors for dust or any other kind of
malfunctioning source.
- Verify the bill thickness adjustment mechanism (feeding gap) in case
it needs to be re-adjusted for improving the unit performance.
- If MG, UV, or DD error messages are reported frequently, proceed to
verify the sensitivity of the function and consider reducing them in
case the current sensitivity value is too high.
To Next Page
