AccuRelief ACRL-9100 - Operating Device with Remote; Device Power Off Procedures

25
STEP 5-Operating the remote controlled device.
NOTE:
You cannot turn the ACRL-9100 unit on by
pressing the remote control. You must do so by
pressing the on/off button on the device itself.
n A steady green light indicator light will turn on to let
you know the unit is on.
n Using the remote control press the Mode button
to switch treatment mode in standby mode.
n Using the remote control press the Program button
to select treatment part in standby mode.
n Using the remote control when the unit is press
the ▲ button to increase or the ▼ button to
decrease the intensity.
NOTE: There are 60 levels of intensity.
STEP 6 - Turn off the device
You can turn device off in the following ways:
■ The device will turn off automatically after 30
minutes treatment time.
■ Press the power button continuously until the
LED light turns off.
■ Turn the remote controlled device off by pressing
the On/Off button on the remote control
n To turn off the device, press the “On/Off” button.
n Remove the electrodes from the skin. Detach
from the edges.
n Remove the device from the electrodes. If you
forget the device for more than 5 minutes,
it turns off. If the device is frequently used during
the day, it is advisable to charge it before starting
a new session.
Step 7 - Following completion of session