Installation & Operation Manual - Model AVT6000
Contents of this Manual are Subject to Change Without Notification Page 4
SECTION 1 - INTRODUCTION
The AVT6000 product family is intended for applications that require accurate and repeatable
airflow measurement with high turn-down that achieves precise control using an external PI
controller. The AVT6000 incorporates a state-of-the-art vortex shedding digital transmitter
with an intuitive user-interface software known as the AccuValve Insight.
1.1 Theory of Operation (Reference the Diagram Below)
The AccuValve
®
divides the airflow into two equal chambers using an airfoil shaped
compression section. Each chamber is comprised of a vortex shedding airflow sensor, a
modulating control surface and a static regain section. As air enters the chambers it accelerates
and compresses, creating an ideal condition for measuring airflow velocity. The vortex
shedding airflow sensors provide a highly repeatable digital pulse-train with a frequency that is
directly proportional to the air flow velocity in each chamber of the AccuValve
®
.
The digital pulses generated by each vortex shedding sensor are used to calculate the total
airflow volume flowing through the AccuValve
®
. The transmitter provides a software-
selectable analog output signal that is directly proportional to the total airflow volume
measurement. The airflow volume can also be provided directly to the building management
system’s BACnet MS/TP network by ordering the optional BACnet MS/TP communications
module.
Field configuration is accomplished through AccuValve Insight, which is an intuitive user-
interface software. Connection between the AVT and the computer is provided through a USB
port located on the AVT transmitter or using the optional Bluetooth connection.
To Next Page
Loading...
