Ace 27201 - Before each Use; Additional Safety Rules

BEFORE EACH USE
CHECK DAMAGED PARTS - Before further use of the tool, a guard or other part that is damaged should be carefully checked
to assure that it will operate properly and perform its intended function. Check for misalignment of binding of moving parts;
breakage of parts, mounting, or any other conditions that may affect its operation. A guard or other part that is damaged should
be properly replaced.
REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and adjusting wrenches are removed
from tool area before turning it on.
MAINTAIN GRINDER WITH CARE. Keep the grinder clean for best and safest performance.
WHEN GRINDER IS RUNNING
Before using your grinder, watch the grinder while it runs. If it makes an unfamiliar noise or vibrates a lot, stop immediately. Turn
the grinder off and unplug it. Do not restart until problem is corrected.
DON'T FORCE TOOL — It will do the job better and safer at the rate for which it was designed.
KEEP CHILDREN AWAY. Keep all visitors a safe distance from the bench grinder. Make sure bystanders are clear of the grinder
and workpiece.
PLAN THE WAY YOU HOLD THE WORKPIECE
Avoid awkward operations and hand positions where a sudden slip could cause fingers or hand to move into grinding surface.
Keep fingers a safe distance from grinding wheel.
DON’T OVERREACH. Keep proper footing and balance at all times.
DIRECTION OF FEED. Feed work into grinding wheel against the direction of rotation of wheel.
AVOID INJURY FROM JAMS, SLIPS, OR THROWN PIECES
Make sure all clamps and locks are tight and no parts have excessive play.
KEEP WORK AREA CLEAN -— Cluttered areas and benches invite accidents.
If small pieces get trapped inside guard, before retrieving material:
Turn switch “off”
Unplug grinder
Wait for all moving parts to stop.
BEFORE LEAVING GRINDER
NEVER LEAVE TOOL RUNNING UNATTENDED. ALWAYS TURN POWER OFF.
Don’t leave tool until it comes to a complete stop.
MAKE THE WORKSHOP CHILDPROOF -— Lock the shop. Disconnect master switches. Store it away from children and others
not qualified to use the tool.
ADDITIONAL SAFETY RULES
Replace a cracked wheel immediately.
Always use guards and eye shields.
Do not over tighten wheel nut.
Use only flanges furnished with this grinder.
Adjust distance between wheel and work rest to maintain 1/16" or less separation as the diameter of the wheel decreases
with use.
Frequently clean grinding dust from beneath the grinder.
Fon
-