How to prime Ace ACE10S 1 HP?
To prime your Ace Water Pump, stop the motor, remove the pressure gauge bushing, and fill the case and suction line with water. Also, ensure all connections are airtight.
What to do if Ace ACE10S 1 HP does not deliver rated capacity?
If your Ace Water Pump is not delivering its rated capacity, use a water-level tester while the pump is operating.
What to do if Ace Water Pump delivers water but will not shut off?
If your Ace Water Pump delivers water but will not shut off, use a water-level tester while the pump is operating to troubleshoot the issue.
What to do if Ace Water Pump motor fails or does not operate properly?
If the motor of your Ace Water Pump fails or does not operate properly, return the pump/motor unit to the place of purchase with proof of purchase for exchange.
Critical instructions to prevent injury and property damage before installation.
Guidelines for safe electrical connections, voltage matching, and proper grounding.
Instructions on how to select and change the pump's operating voltage.
Guide for making electrical connections, including grounding the pump.
First three steps for installing a shallow well pump, focusing on foot valve and pipe assembly.
Continues shallow well pump installation with well seal, elbow, and pump adapter connections.
Specific steps for installing the ejector kit on ACE5C and ACE10C convertible pumps.
Connects pump to discharge tee, pressure gauge, priming, and pressure tank setup.
Finalizing shallow well setup, including tank pressure and pump startup.
Common pump problems and their potential causes for diagnosis.
General| Brand | Ace |
|---|---|
| Model | ACE10S 1 HP |
| Category | Water Pump |
| Language | English |
To Next Page
