Ace ESP-200A 2 HP - User Manual

Questions and Answers

R
Roberta FloresAug 9, 2025
Why Ace Irrigation System pump does not deliver rated capacity?
- R
  rlawrenceAug 9, 2025
  Several factors could be at play. It might be due to insufficient submergence of the suction pipe; ensure it's at least 3 feet below the water level. Verify that the pump's voltage matches the power supply voltage. Check the valve, suction piping, foot valve, or well point for any issues. The discharge system head might be too great, or the well depth could exceed the pump's capacity. The pump flow might be greater than the well flow capability. Ensure all connections are airtight and that the suction pipe isn't too small; it should be a 1-1/2" pipe.
R
rhowardAug 19, 2025
What to do if Ace Irrigation System pump will not prime?
- M
  Michael LopezAug 19, 2025
  If your pump isn't priming, try these steps: Stop the motor, remove the 1-1/2" pipe plug, and fill the case with water. Ensure the pump voltage matches the power supply voltage. Inspect the valve, suction piping, foot valve, or well point. The foot valve might be sitting in sand or mud, stuck shut, or leaking. Check all connections to ensure they are airtight and check for a leaky shaft seal.
J
John HillAug 29, 2025
Why Ace Irrigation System pump loses prime after starting?
- S
  Stephanie MartinAug 29, 2025
  The issue might be caused by several reasons. The suction pipe might not be submerged enough; it needs to be at least 3 feet below the water level. The well depth might exceed the pump's capability, or the pump flow might be greater than the well's flow capability. Make sure that all connections are airtight.