Warning !
Follow all warnings and instructions marked on the product !
Danger ! High internal operating voltages.
Do not open the equipment case. There are no user serviceable parts in this equipment. Refer all
servicing to qualified service personnel.
Clean only with a dry cloth.
Condensation can form on the inside of an amplifier if it is moved from a cold environment to a
warmer location. Before switching the unit on, it is recommended that the unit be allowed to reach
room temperature.
Unauthorised modification of this equipment is expressly forbidden by Ace Amplification.
Never push objects of any kind into ventilation slots on the equipment casing.
Do not expose this apparatus to rain, liquids or moisture of any type.
Follow all warnings and instructions marked on the product !
Do not place this product on an unstable trolley, stand or table. The product may fall, causing
serious damage to the product or to persons !
Do not cover or block ventilation slots or openings.
This product should not be placed near a source of heat such as a stove, radiator, or another heat
producing amplifier.
Use only the supplied power cord which is compatible with the mains voltage supply in your area.
Power supply cords should always be handled carefully and should be replaced if damaged in any
way.
Never break off the earth (ground) pin on the power supply cord nor disconnect the protective
mains earth connection.
The power supply cord should be unplugged when the unit is to be unused for long periods of time.
Before the unit is switched on, the loudspeaker should be connected as described in the handbook
using the lead recommended by the manufacturer.
High loudspeaker levels can cause permanent hearing damage. You should therefore avoid the
direct vicinity of loudspeakers operating at high levels. Wear hearing protection if continuously
exposed to high levels.
If the product does not operate normally, when the operating instructions are followed, then refer
the product to a qualified service engineer.
All electrical and electronic products should be disposed of separately
from the municipal waste stream via designated collection facilities
appointed by the government or the local authorities.
3