Front Panel
1. Guitar Input
Plug your guitar in here. Always use a good quality screened guitar lead.
2. Gain (Clean channel)
The Gain control adjusts the amount of the Clean Channel’s overdrive.
Low settings, counter clockwise (CCW), will deliver a bright clean sound. As the Gain control is
increased clockwise (CW) the sound will become more thick.
From 12 o’clock, according to the guitar, the sound will become more overdriven moving through a
big crunch at the end of the control race.
3. Channel Select Switch
Press this switch to select the Overdrive Channel.
Switch to the left : Clean Channel.
Switch to the right : Overdrive Channel.
4. Gain (Overdrive Channel)
The Gain control adjusts the amount of the Overdrive Channel’s overdrive or distortion.
Low settings, counter clockwise (CCW), will deliver a clean sound.
As the Gain control is increased clockwise (CW) the sound will become more overdriven moving
through crunch tones until, at its maximum position, a full distorted lead tone is arrived at.
5. Bass (Overdrive Channel)
This control affects the low end frequencies of the Overdrive Channel. Turning it clockwise
increases the amount of bass present.
6. Middle (Overdrive Channel)
This control affects the mid range frequencies of the Overdrive Channel. Turning it clockwise
increases the amount of mid present.
5
To Next Page
Loading...
General