2-20 Altos 500 System Guide
Follow these steps when installing an AGP card:
1. Locate the AGP slot on the mainboard.
2. Insert an AGP card into the slot. Make sure that the card is
properly seated.
When you turn on the system, BIOS automatically detects and
assigns resources to the AGP device.
BIOS detects and configures only PnP cards.
Error Messages
Do not continue using the computer if you receive an error message of
any type. Note the message and take corrective action. This section
describes the types of error messages and lists their corresponding
corrective measures.
There are two general types of error messages:
•
Software
To Next Page
Loading...
