1-23 Hardware Specifications and Configurations
LAN Interface
Item Specification
LAN Chipset Realtek RTL8411B
LAN connector type RJ45
LAN connector location JRJ45 at the left side
Features
Hardware
• Integrated 10/100/1000M transceiver
• Auto-Negotiation with Next Page capability
• Supports PCI Express 1.1
• Supports 1-Lane 2.5Gbps PCI Express Bus
• Supports pair swap/polarity/skew correction
• Crossover Detection & Auto-Correction
• Wake-On-LAN support
• Embedded OTP memory can replace the external
EEPROM
• Transmit/Receive on-chip buffer support
• Supports hardware ECC(Error Correction Code) function
• Supports hardware CRC(Cyclic Redundancy Check)
function
• Customizable LEDs
• Controllable LED Blinking Frequency and Duty Cycle
• Built-in switching regular
• Built-in LDO regulator
• Supports PCI MSI (Message Signaled Interrupt) and MSI-X
• Supports LTR(Latency Tolerance Reporting) and OBFF
(Optimized Buffer Flush/Fill)
• Supports 16-set 128-byte Wake-Up Frame pattern ex-act
matching
• Supports Microsoft WPD (Wake Packet Detection)
• Supports PCIe L1.Off and L1.Snooze
• Embeds an adaptive equalizer in-PCI Express PHY (PCB
traces to reach up to 20cm)
• Supports power down/link down power saving/PHY disable
mode/LAN disable mode
IEEE
• Fully complies with IEEE 802.3, IEEE 802.3u, IEEE
802.3ab
• Supports Full Duplex flow Control (IEEE 802.3x)
• Supports IEEE 802.IP Layer 2 Priority Encoding
• Supports IEEE 802.1Q VLAN tagging
• Supports IEEE 802.3az-2010 (EEE)
To Next Page
Loading...
