43
Machine Disassembly
This chapter contains step-by-step procedures on how to assemble the monitor for
maintenance.
Disassembly Procedure
Disassemble the base
1. Remove the neck cover.
2. Remove the four screws to release the hinge.
3. Remove the base
Disassemble the chassis
1. To fix the LVD cable with the panel,and stick
2. To fix the main frame on the panel
3. give the panel to lock the Screws
4.To fix the power board on the main frame with screws
1. To fix the audio board together with power board
6.To connect the main board with audio board and LVD cable
7.To fix the main board with screws.
8. To put the bezel on level place
9. To cover the panel with front bezel
10. To fix the shield on the main frame with screws
11. To put and fix the rear cover with screws
12. take the base together with interfaces
13. so the monitor was finishing!
1 2 3 4 5
6 7 8 9 10
Chapter 3
To Next Page
Loading...
