48 Chapter 3
Disassemble the Bluetooth and Cables
1. Disconnect the bluetooth cable from the left side of mainboard.
2. Remove the two screws to release the bluetooth board.
3. Then take the bluetooth module away from the system.
4. Release the tabs on both side before you disconnect these cables. The first cable is card reader cable,
secondly is cd-player flat flexible cable, the third is touch pad cable
Disassemble Case, Touchpad and CD-Player
1. Remove the one screw located as highlight on the top case.
2. Remove the fourteen screws located on the base.
3. Detach the top case out from the system.
4. Pull up the tabs on both side to disconnect the CD-Player flat flexible cable from the CD-Player board.
5. Pull the tabs on both side forward to disconnect the touchpad cable from the mainboard.
6. Remove the two screws to release the touchpad board.
7. Then detach the touchpad board from the support.
8. Tear tape on these positions to disconnect the cables.
9. Pull the tabs on both side forward to disconnect the cables from touchpad board.
To Next Page
Loading...
