Acer Aspire 4810TZ Series - Removing the System Board

Chapter 3 61
16. Carefully remove the LCD module from the base unit.
NOTE: When connecting the cables back to the unit, please note that the cables should be routed well.
Removing the System Board
1. See “Removing the Battery Pack” on page 44.
2. See “Removing the Lower Cover” on page 45.
3. See “Removing the Lower Cover” on page 45.
4. See “Removing the Optical Drive Module” on page 46.
5. See “Removing the DIMM” on page 46.
6. See “Removing the Hard Disk Drive Module” on page 47.
7. See “Removing the SSD Module” on page 48.
8. See “Removing the RTC Battery” on page 48.
9. See “Removing the Keyboard” on page 51.
10. See “Removing the WLAN Board Module” on page 52.
11. See “Separating the Upper Case from the Lower Case” on page 53.
12. See “Removing the LCD Module” on page 59.
13. Disconnect the card reader board cable from the system board.