Chapter 3 123
Replacing the USB Board
3. Align the screw sockets and replace the two
screws.
4. Secure the Modem cable in place with the
adhesive tape.
1. Insert the USB Board into the casing, ensuring that
the USB Port is accessible through the case.
2. Run the cable along the casing and insert it into the
FFC connector.
3. Lock the connector and press down on the FFC
cable to secure it on the casing.
4. Ensure the locating pins is correctly seated and
replace the single securing screw.
Locating Pin
To Next Page
Loading...
