Chapter 3 107
2. Replace the four securing screws (two each side), starting with the left side hinge.
NOTE: Two different screw sizes are used to secure the LCD module in place. The red callouts require
M2.5*15 screws and the green callouts require M2.5*10 screws.
3. Push the antenna cables through the chassis and
pull them all the way through from the underside.
4. Place the antenna cable in the cable channel using
all the cable clips as shown.
5. Reconnect the LCD power cable as shown. 6. Place the power cable in the cable channel using
all the cable clips as shown.
To Next Page
Loading...
