Chapter 3 63
Disassembling the LED boards
11. Loose the LED boards four screws.
12. Remove two LED boards from the machine.
13. Loose four LCM hinge screws.
14. Then remove LCM module from the machine.
Remove I/O baord and Main Board.
15. Loose the daughter board screw then remove the daughter board from the machine.
16. Disconnect four cables on the M/B as shown.
17. Loose the M/B screw, remove RJ11 connector from the BTCB.
18. Remove M/B from the BTCB..
19. Disconnect LED/B cable and USB/B FFC.
To Next Page
Loading...
