Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Picture8
Step 9:
Step 10:
1-4: Create SATA RAID 0+1
Shut down the EUT, unplug the power cable,connect four SATA HDDS to EUT , check the
EUT all devices are connect/plug ok
Press "PWR-BTTN" to power on the EUT,Load BIOS default setting .
At "Integrated_Peripherals" page "OnChip SATA Type" item set is as "RAID" mode,save
and exit.
During BIOS post, press <Ctrl-I> to enter into Intel RAID setup utility.
Select "1" to enter create RAID mode ,if there is no enough avalable space (there was exist a
Raid , delete it ).
Repeat RAID1 creation step and exit,then install OS.
Create RAID 0+1 Mode,firstly create RAID 0 Mode,enter the RAID name,such as
"MyRaid0+1",default is"Volume0".
Select "RAID0(Stripe)" at "RAID Level".
Select two HDDs in "Disk" by space key.
Press "Enter" to finish HDD selection and it will back to RAID creation interface.
To Next Page
Loading...
