Chapter 5 61
Jumper Setting
This section explains how to set the jumper for correct configuration of the main board.
Jumpers with more than one pin are numbered. When setting a jumper, ensure that the jumper caps are
placed on the correct pins.
Jumper Type Description Setting (default) Picture
CLR_CMOS1 3-pin Clear CMOS 1-2: Normal
2-3: Clear
Before clearing the CMOS, make sure
to turn the system off.
ME_CLR1 3-pin Clear ME 1-2: Normal
2-3: ME disabled
To Next Page
Loading...
