System Utilities 2-14
DOS Flash Utility
NOTE:
Plug the AC power adaptor to a power source before performing the DOS Flash Utility.
Perform the following to use the DOS Flash Utility:
1. Copy the DOS mode flash files to the USB HDD.
2. Press F2 during boot to enter the BIOS Setup Utility.
3. Select Boot menu to modify the boot priority order.
4. Move the USB HDD to position 1 (refer to Boot on page 2-10).
Figure 2:13. Changing the BIOS Boot Priority Order
5. Insert the USB HDD and reboot the computer.
6. Enter the BIOS folder.
Figure 2:14. Flash files
F9 Setup Defaults
F10 Save and Exit
F1
Esc
Help
Exit
Select Item
Select Menu
Enter
F5/F6
Select Sub-Menu
Change Values
InsydeH20 Setup Utility Rev. 3.7
Item Specific Help
Use <ʅ> or <ʆ> to select a device, then
press <F5> to move it down the list, or
<F6> to move it up the list. Press <Esc>
to escape the menu
Boot priority order:
1. Network Boot : BRCM MBA Slot 0200 v15.0.11
2. USB FDD :
3. HDD0 : TOSHIBA MK7559GSXP
4. USB HDD :
5. USB CDROM :
6. ATAPI CDROM : MATSHITABD-CMB UJ160
Information Main Security ExitBoot
C:\ROMs\Q5Wx8100\DOS>dir
Volume in drive C is ISS_4GB
Volume Serial Number is 3666-33A4
Directory of C:\ROMs\Q5Wx8100\DOS
. <DIR> 06-04-2010 14:31 .
.. <DIR> 06-04-2010 14:31 ..
FLASHIT EXE 102,912 07-19-2011 2:24 FLASHIT.EXE
Q5Wx8100 BAT 321 04-03-2012 14:32 Q5Wx8100.BAT
Q5Wx8100 FD 4,194,304 04-03-2012 14:31 Q5Wx8100.FD
K74E100A ROM 131,072 04-03-2012 13:10 K74E100A.ROM
MIDCHK EXE 14,164 01-11-2011 16:52 MIDCHK.EXE
5 file(s) 4,442,773 bytes
2 dir(s) 2,524,848,128 bytes free
To Next Page
Loading...
