System Utilities 2-26
3. Press and hold <Fn> and <Esc>, and then plug the AC adapter.
Figure 2:36. Hold Down <Fn> + <Esc> and plug the AC Adapter
4. Press the Power button to start the Crisis Utility.
Figure 2:37. Press the Power Button
NOTE:
If the Crisis Utility does not starts after 5 minutes, this indicates that the system recovery is
failed.
Do the following:
1. Make sure the USB crisis disk file name is correct.
2. Unplug the AC adapter, then remove and install again battery to reset the embedded
status.
3. Retry step 1~4.
To Next Page
Loading...
