2-16 System Utilities
WinFlash Utility 0
Perform the following to use the
WinFlash Utility
:
1. Open “Formal” folder in BIOS version folder.
2. Copy the WinFlash executable
ZQK_200.EXE
to desktop.
3. Plug in the AC power and run
ZQK_200.EXE
as admin as shown in Figure 2-15.
Figure 2-15. Run as admin
4. System will switch to DOS mode and begin to Flash BIOS as shown in Figure 2-13.
5. System will restart automatically when the Flash Process finished.
6. Press
F2
during boot to enter Setup Menu.
7. Press
F9
for Setup Default and
F10
for Save and Exit.
8. Press
F2
during boot to enter Setup Menu.
9. Ensure the System BIOS version has been updated.
Figure 2-16. Run as admin
This feature is only functional when the AC power adapter is connected. It
is recommended to have the AC adapter and Battery present when using
WinFlash Utility.
To Next Page
Loading...
