Acer B223W - Potentially explosive environments; Additional safety information; IT Equipment Recycling Information

Acer Acer –LCD-B223W
5
(DC output full loading and nominal AC input voltage range)
3.1.6 Ripple and Noise
Total composite ripple and noise less than 320mV for +16V output, and less than 150mV for +5V output, and 50mV for
+3.3V output tested by DC loading side parallel with a 47uF/EC and 0.1uF/Ceramic. Capacitors and measured band-width
with DC-20MHz
3.1.7 DC Output Voltage and Current
Current
DC Output Voltage
Typ. Max.
VCC16V 15.2V-18.5V 1.8A 2.2 A
VCC5V 4.75~5.25V 1.5A 1.8A
Note: For the normal loading test ,the output loading use typical current.
3.1.8 Protection
a. SCP: For short circuited protection and with auto-recovery function.(
for 5V output it must be shorted before F802)
b. OPP: Over-power protection, Range: 60W ( min ) on nominal AC input.
c. BOP: Br
own Out protection
Condition: Pattern: Dot pattern,
Timing: 1680x1050 60Hz,
Brightness: Max.
Contrast: Max
Spec: system shutdown voltage must be > 50V
system restart voltage must be <85V
3.1.9 Power consumption
Max. 55W.
Follow Energy Star V4 condition 49W
3.1.10 Power management
BV223W supports Energy Star V4 and VESA DPMS
Status H-sync V-sync Video Power LED
On Mode/Active Power on on active ≤ 55W Blue
off on blanked < 2W Orange
on off blanked < 2W Orange
Sleep Mode/Low Power
off off blanked < 2W Orange
Off Mode/Standby Power -- -- -- < 1W Off
3.2 Backlight
Item Symbol Min. Typ. Max. Unit Remark
Input Voltage Vin 15.2 16.0 18.5 V
Von 2.0 3.3 5.5 V
Enable (On/Off)
Voff -0.3 --- 0.8 V
Kick off Voltage:
Item Symbol Min. Typ. Max. Unit Remark
Kick off Voltage Vs
1700 --- --- Vrms