Acer C250i - About Your Remote Controller; Initial Setup and Usage

About Your Remote Controller
Operating Instructions
1. Preparation at 1st time usage
Insert Acer WirelessProjection-Kit (UWA5 Wi-Fi dongle) into the WIRELESS KIT port on
projector. (See picture 1)
(Remark: The Wi-Fi dongle cannot be removed after plugging-in)
Plug the power adaptor in your projector depending on landscape mode or portrait mode.
Charge your projector by 3 hours at 1st time usage. (See picture 2)
(1)
(2)
(3)
(4)
(5)
To turn on projector, long press the power button of the projector for 3 seconds or press
power key on remote controller directly.
Adjust focus ring until the projection image is clear and focused.
Select your preferred start-up language.
Power key to turn on/off projector
Quick key to enter Bluetooth music mode
Confirmation key
4 direction keys
Back key
Quick key to enter home menu
Quick menu key
Volume up / down
Function
1
2
3
4
5
6
7
8
NO
Remark:
1. Batteries are not included.
2. Wi-Fi setting and advanced settings can be controlled by remote
controller only.
3. Powering on projector via remote controller is available while adaptor
is plugged in.
(Picture 1) (Picture 2)