Disassembly Procedures 1-13
WWAN (Wireless Wide Area Network) Module Removal
(For C732L & C732LT only) 0
Prerequisite:
Battery Pack Removal
1. Find the WWAN module (B) on the top assembly. Refer to Figure 1-10.
2. Disconnect WWAN antennas (A) connected to the WWAN card (Figure 1-16).
3. Remove one (1) screw (C) securing the WWAN module in place (Figure 1-16).
Figure 1-16. WWAN Module Removal
4. Remove the WWAN module (B) from the LTE board connector (D) (Figure 1-17).
Figure 1-17. WWAN Module Removal
B
D
WEEE Annex VII Component: WWAN Module
To Next Page
Loading...
