60 - BIOS utility
BIOS UTILITY
The BIOS utility is a hardware configuration program built into your
computer's BIOS.
Your computer is already properly configured and optimized, and you
do not normally need to run this utility. However, if you encounter
configuration problems, you may need to run it.
To activate the BIOS utility, press F2 while the computer logo is being
displayed.
Boot sequence
To set the boot sequence in the BIOS utility, activate the BIOS utility,
then press F1 to access Advanced Settings to select Boot from the
categories listed on the left of the screen.
Setting passwords
To set a password on boot, activate the BIOS utility, then press F1 to
access Advanced Settings to select Security from the categories
listed on the left of the screen.
Find Set Supervisor Password and enter a password to enable this
feature. Once you have entered a password for this feature, you may
then enable/disable Password on Boot.
Remember to select F10 to properly save and exit the BIOS utility
when you are done making changes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
