LCD Monitor Quick Start Guide - 1
Acer LCD Monitor Quick Start Guide (QSG)
Important safety instructions
Please read the following instructions carefully.
1. To clean the LCD monitor screen: Be sure that your monitor is electrically
rated to operate with the AC power available in your location.
• Turn off the LCD monitor and unplug the power cord.
• Spray a non-solvent cleaning solution onto a rag and clean the screen
gently.
• NEVER SPRAY OR POUR ANY LIQUID DIRECTLY ONTO THE
SCREEN OR CASE.
• PLEASE DO NOT USE ANY AMMONIA OR ALCOHOL-BASED
CLEANERS ON THE LCD DISPLAY SCREEN OR CASE.
• Acer will not be liable for damage resulting from use of any ammonia or
alcohol-based cleaners.
2. Do not place the LCD monitor near a window. Exposing the monitor to
rain, moisture or sunlight can severely damage it.
3. Do not apply pressure to the LCD screen. Excessive pressure may cause
permanent damage to the display.
4. Do not remove the cover or attempt to service this unit yourself. An
authorized technician should perform servicing of any nature.
5. Store the LCD monitor in a room with a temperature of -20° to 60°C (-4° to
140°F). Storing the LCD monitor outside this range may result in
permanent damage.
6. Immediately unplug your monitor and call an authorized technician if any
of the following circumstances occur:
• Monitor-to-PC signal cable is frayed or damaged.
• Liquid spills onto the LCD monitor or the monitor is exposed to rain.
• The LCD monitor or case is damaged.
7. EI292CUR can be overclocked to a higher refresh rate than advertised by
the panel specification. This function can be use the system control panel
to set the maximum refresh rate.
Important: This device is designed to support refersh rate overclocking.
However, overclocking may result in system instability. If you experience
instability, try reducing the overclock to a lower refresh rate through the
on-screen disply settings.
To Next Page
Need help?
General
