3
Software Installation
Software Installation Software Installation
Software Installation
a) Microsoft Windows
95 /
98 /
2000
If you are using Windows
95
, Windows
98
or Windows
2000
as an
operating system you have to set up the correct monitor driver.
Windows
95
The first time you start Windows with a new monitor, the system will detect it
and automatically installs the driver for plug and play displays. To install the
current driver from DISK, proceed as follows:
1. Click “Start“ then “Settings“.
2. Double click the “display“ icon in the control panel.
3. From the “Display properties“ window, select the “Settings“ tab.Click the
“Advanced properties“button in the bottom right corner.
4. Select the “monitor“ tab.Click the “change“ button in the top right corner.
5. Now click the “Have disk“ button in the bottom right corner. Another
window appears, select the “Search“ button.
6. The drive selection is located at the bottom of the window in the centre.
Insert the DISK supplied with your monitor into your computer.
7. In the field of drive selection, change to the floppy driver. The current
driver files are located there. Press “OK“ and the window closes.
8. By pressing “OK“ again in the next window you will be given a list of
compatible devices. Select the model of your monitor from the list and
press “OK” again.
9. Now you are back to “Advanced graphics properties“.Close this window
by clicking “OK “ and confirm the following messages with “Yes“ Click
“OK “ and “Yes“once more. The installation is now complete. You can
now close “Display Properties“.
Windows
98
The first time you start Windows with a new monitor, the system will detect it
and automatically starts the “Add new hardware wizard“. Carry out the
instructions beginning at step 4.
2
To Next Page
Loading...
