Acer H236HL - Acer Ecolor Management; OSD Message


19


2.4 Acer eColor management:
a. Display Acer eColor Management OSD when user press “e” button at Function menu or trigger this
function in OSD menu/picture page.
b. Layout as following figure:

2.5 OSD Message:
Item Description
AutoConfig
PleaseWait
WhenUserPressHot‐Key“Auto”,willshowthismessage,andthemonitordotheautoconfig
function.
InputNotSupported When the Hsync Frequency, Vsync Frequency or Resolution is out of the monitor support
range,willshowthismessage.Thismessagewillbeflying.
CableNotConnected When the video cable is not connected, will show this message. This message will be flying
withorangeLED,andmuteafterabout60Secs.
NoSignal Whenthevideocableisconnected,buttheisnoactivesignalinput,will showthismessage,
thenenterpowersaving.
PleaseWait Afterusertriggertheresetfunction,systemwillshowthismessagetonoticeusertheresetis
inproceeding