1-16 Hardware Specifications and Configurations
Hard Disk Drive Interface
Audio Codec Interface
Item Specification
Vendor &
Model Name
Sandisk
S IC FL 16G SDIN5C1-16G TFBGA
169P
Samsung
S IC FL 32G KLMBG8FEJA-A001
FW PA33
Capacity
(GB)
16G 32G
DC Power Requirements
Voltage
tolerance
VCC: 2.85V
VCCQ: 1.8V
Item Specification
Audio Controller WM8903LGEFK
Audio onboard or optional On board
Mono or Stereo Stereo
Resolution 24-bit data resolution
Compatibility I2S Interface;
Sampling rate Sample rate up to 44.1KHz
Internal microphone Yes
Internal speaker/quantity Yes / (0.5W stereo speakers x2)
Phone Jack HP_Out + MIC
Feature
• 4.5mW power consumption for DAC to headphone
playback
• DAC SNR 96dB typical, THD -86dB typical
• ADC SNR 92dB typical, THD -80dB typical
• Control sequencer for pop minimized start-up and shut-
down
• Single register write for default start-up sequence
• Integrated FLL provides all necessary clocks
• Self-clocking modes allow processor to sleep
• All standard sample rates from 8kHz to 96kHz
• Stereo digital microphone input
• 3 single ended inputs per stereo channel
• 1 fully differential mic / line input per stereo channel
• Digital Dynamic Range Controller (compressor / limiter)
• Digital sidetone mixing
• Ground-referenced headphone driver
• Ground-referenced line outputs
• Stereo differential line driver for direct interface to
WM9001 speaker driver
• 40-pin QFN package (5x5mm)
To Next Page
Loading...
