47 Chapter 4
Performance Troubleshooting (Computer Signal)
A. Have Image?
- Ensure the Signal cable and Source work as well.
- Check that can OSD Menu show on the screen.
- Check the Main board.
- Check the DMD board.
B. Have Garbage Pattern?
- Ensure the Signal cable and Source work as well.
- Check the Main board.
- Check the DMD board.
C. Uniformity OK?
- Ensure the Projection screen without dirty.
- Ensure the Projection lens is clean.
- Ensure the Brightness is within spec.
(Replace the Lamp if the Brightnedd is less than spec.)
- Check the Optical engine.
D. Is Color OK?
- Ensure the Signal cable works as well.
- Check the “Color wheel index” in the service mode of OSD Menu.(*Note)
- Check the Photo sensor.
- Check the Main board.
- Check the DMD board.
E. Dot Defect isn’t Compliant with the Spec.
- Ensure the Projection lens is clean.
- Use the Air gun for the Optical engine clean.
- Check the DMD chip.
F. Have Noise?
- Ensure the Signal cable and Source is work as well.
- Adjust the Tracking selection in OSD Menu.
- Press the Menu button to check that have the noise issue appear on
OSD Menu.
(Check the DMD board if the noise also appear on the OSD Menu.)
To Next Page
Loading...
