Acer PD726 - Page 20

Chapter2 14
No Step Procedure Photo
7
1. Choose “Flash
Loader”
2. Click “Browse” to
search the firmware
file. (PD726 / PD730)
3. Select the item “Skip
Boot Loader Area
(load all but the first
64KB).”
4. Click “Reset Bus” to
erase the flash
memory.
(Note: If the error mes-
sage “cannot open USB
driver - No projectors
found” appears, please
unplug the USB Cable
and replug, then check
Driver. Finally, re-do
4. Click “Reset Bus” to
erase the flash memory.)
8
1. If the firmware is
ready, click “Start
Download” to process
the firmware upgrade.
2. Click “Yes” to erase
the flash memory.
Note:
1
2
3
4
1
2