72 - Video and audio connectors
VIDEO AND AUDIO CONNECTORS
Connect to a monitor with a video port (the type of
connection supported depends on your computer’s
configuration). The appropriate cable is usually included with
the monitor.
Follow these steps to connect an monitor to your computer:
1. Check that the computer is powered off and the monitor
power switch is turned off.
2. Attach the video cable to the monitor port on the computer.
Secure the cable connection with the screws provided.
3. Connect the monitor power cable and plug it into a
properly grounded wall outlet.
4. Follow any setup instructions in the monitor's user's guide.
5. Turn on power to the monitor, then the computer.
6. Make sure that the current resolution and refresh rate do
not exceed the specifications of the monitor. If necessary
change the display settings used by the computer.
Headphones and microphone
These ports allow you to connect audio devices. Use the
headphone port to plug in stereo headphones or powered
speakers. Plugging an audio device to the headphone port
disables the built-in speakers. Use the microphone port to
connect an external microphone for mono recording; plugging
in an external microphone disables the built-in microphone.
To access the display controls, press the Windows key ( ) + W,
type "Display" and then click on Display.
Some computers have a single "combo" port that allows you to use
single-pin headsets with a built-in microphone. These headsets are
most commonly used with smartphones.
To Next Page
Loading...
