--- ---
Hor. Position
---
0 ~ 100 50
Ver. Position
---
0 ~ 100 50
OSD
OSD Timeout
---
10~ 120 20
Analog
--- --- ---
Digital
--- --- ---
Input (Dual)
DDCCI ON/OFF
ON
Input (Analg
only)
DDCCI ON/OFF
ON
Resolution
--- --- ---
H. Freq
--- --- ---
V. Freq
--- --- ---
Info
S/N
ETL000….0000(22)
Reset
--- --- --- ---
Exit
--- --- --- ---
Notes: 1. Clock default 50 is for Visa timing. Others depend on timing.
5.3.1 OSD Function Test
3.1.1 Test mode: 1280x1024 @ 60 Hz
3.1.2 Test pattern: pattern #1 of crosshatch (GENERAL-1)
3.1.3 Check single key function and hot key function about key “Power”, “Menu”,” ►”, “◄ “, “Exit/Auto”, “[e
Color ]” it should operate normally
5.3.2 Screen Picture Check
5.3.3 Test mode: 1280x1024 @ 60 Hz
5.3.4 Test pattern: pattern #1 of crosshatch (GENERAL-1)
5.3.5 Select OSD menu to execute ‘Auto’ function, screen picture shouldn’t appear abnormal phenomenon and
picture on screen should fit in with active display screen.
5.4 Auto Color Balance
5.4.1 Test mode: 640X480 @ 60 Hz
5.4.2 Test pattern: pattern #42 of 5 mosaic pattern
5.4.3 Enter "Factory Mode" pressing "MENU" key, execute "AUTO".
5.4.4 When Color Balance finished, Must push “POWER” key to exit “Factory mode”, and restart.
5.5 Timing Check
5.5.1 Test mode: Refer to preset timing table and power saving mode
5.5.2 Test pattern: pattern #1 of crosshatch (GENERAL-1)
5.5.3 After change above timing and execute “Auto” function automatically, picture should fit in with active
display screen.
5.5.4 Under power saving mode, LED lamp on the key board should be orange
5.6 Power Consumption Function Test
5.6.1 Test mode: 1280x1024 @ 60 Hz
5.6.2 Test pattern: pattern #41 of “WHITE”
5.6.3 Adjusting both brightness value to maximum,
5.6.4 Measure power consumption as the following
Status Power Consumption LED Display
Normal < 35W Green
To Next Page
Loading...
