13
Distance between Bright dots L ≥ 15 mm
●
Distance between Dark dots L ≥ 15 mm
●
Note 1: Dot defect is defined as the defective area is not larger than 50% of the dot area. Bright Dot is defined 5%
transmission ND filter.
Note 2: Light Leakage: There shall not be visible light around the customer’s bezel after assembly in normal View
angle.
7. SOP of firmware upgrade (
Manufacturer of Scaler is RealTek)
7.1 Operational condition:
Defect Type Specification Size Count (N)
Major Minor
Dot Shape (Particle、Scratch
and Bubbles in Display area or
on The Polarizer)
Black spots which appear when
B/L operating
0.1 ≤ D ≤ 0.7 mm (AMLCD)
0.15 ≤ D ≤ 0.5 mm (CPT & LPL)
0.05 ≤ D ≤ 0.15 mm (INL)
N ≤ 4
N ≤ 4
N ≤ 3
●
0.3mm ≤ L ≤ 5.0mm
0.01≤W≤0.1mm
N ≤3
(for Sam)
●
1mm ≤ L ≤ 10mm
0.01≤W≤0.05mm
N ≤4
(for LPL)
L ≤3mm
W ≤ 0.1 mm
N ≤4
(for CPT)
●
Line Shape (Particles, Scratch,
Fiber and Bubbles in display
area or on The Polarizer)
0.3mm ≤ L ≤ 10mm
0.05mm ≤ W ≤ 0.15 mm
N ≤4
(For INL)
Display non-uniformity
There should be non-uniformity through 5%
transparency of filter or judge by limit sample if
necessary.
●
Scratch ●
Dirt
No harm
●
Wrap No harm ●
Bezel
Sunken No harm ●
No label ●
Invert label ●
Broken
No
●
Dirt Word can be read. ●
Not clear ●
Word out of shape
●
Mistake No ●
Label
Position Be attached on right position ●
Not enough No ●
Screw
Limp No ●
Connector Connection status No bend on pins and damage ●
FPC/FFC Broken No ●
To Next Page
Loading...
