Acer V193W

Service Guide Acer V193W
Operating Instructions Chapter 3
Installation
To install the monitor on your host system, please follow the steps below:
1 Connect the video cable
A：Make sure both the monitor and computer are switched off.
B：Connect the VGA video cable to the computer.
2 Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Turn on the monitor and computer
Turn on the monitor first, then the computer. This sequence is very important.
4 If the monitor does not function properly, please refer to the troubleshooting section to diagnose the problem.
Attaching/Removing the Base
Attaching:
Align the release button on the bottom of the monitor with the corresponding slots on the bottom of the base.
Removing:
Press the release button as indicated, then pull in the direction of the arrow to remove the base.
16