Service Guide Acer V193W
to oper
ate properly, there must be a video input signal.
This monitor meets the Green monitor standards as set by the Video Electronics Standards Association (VESA)
and/or the United States Environmental Protection Agency (EPA) and The Swedish Confederation Employees
(NUTEK). This feature is designed to conserve electrical energy by reducing power consumption when there is
no video-input signal present. When there is no video input signals this monitor, following a time-out period, will
automatically switch to an OFF mode. This reduces the monitor's internal power supply consumption. After the
video input signal is restored, full power is restored and the display is automatically redrawn. The appearance is
similar to a "Screen Saver" feature except the display is completely off. Pressing a key on the keyboard, or
clicking the mouse restores the display.
Using The Right Power Cord
The accessory power cord for the Northern American region is the wallet plug with NEMA 5-15 style and is UL
listed and CSA labeled. The voltage rating for the power cord shall be 125 volts AC.
Supplied with units intended for connection to power outlet of personal computer: Please use a cord set
consisting of a minimum No. 18 AWG, type SJT or SVT three conductors flexible cord. One end terminates with
a grounding type attachment plug, rated 10A, 250V, and CEE-22 male configuration. The other end terminates
with a molded-on type connector body, rated 10A, 250V, having standard CEE-22 female configuration.
Please note that power supply cord needs to use VDE 0602, 0625, 0821 approval power cord in European
counties.
Factory mode OSD
It is necessary that Factory mode is emerged for check the Panel and soft information .
for enter the Factory mode:
Conditions in the power-off, Press
button and hold, press ,power on the monitor, then ,press MENU ,
the monitor will may enter Factory OSD Menu. Then Press MENU
, Factory OSD Menu will appear in the
screen.
23
To Next Page
Loading...
