To Next Page
C
christine08Aug 20, 2025
What to do if my Acer Veriton 2800 has 'Powering issues when pressing power switch'?
- JJennifer BentonAug 20, 2025
Ensure the 'Soft-off by PWR-BTTN' in BIOS Setup of Power Management is not set to 'Instant-off'.
What to do if my Acer Veriton 2800 has 'Powering issues when pressing power switch'?
Ensure the 'Soft-off by PWR-BTTN' in BIOS Setup of Power Management is not set to 'Instant-off'.
What to do if I get a 'Keyboard Error Or No Keyboard Present' on my Acer Veriton 2800 Desktop?
This error means the system can't initialize the keyboard. First, ensure the keyboard is correctly connected and that no keys are being pressed during the POST (Power-On Self-Test). If you intend to use the system without a keyboard, configure the error halt condition in Setup to 'HALT ON ALL, BUT KEYBOARD'.
What to do if my Acer Veriton 2800 Desktop says 'HARD DISK INSTALL FAILURE'?
This message indicates the system cannot find or initialize the hard drive controller or the drive itself. Check that the controller is correctly installed. If you don't have any hard drives installed, make sure the 'Hard Drive Selection' in Setup is set to 'NONE'.
What to do if my Acer Veriton 2800 Desktop says 'Floppy disk(s) fail'?
This message means that the system cannot find or initialize the floppy drive controller or the drive. Make sure the controller is installed correctly. If no floppy drives are installed, be sure the 'Diskette Drive' selection in Setup is set to 'NONE' or 'AUTO'.
What to do if my Acer Veriton 2800 Desktop says 'CMOS Checksum Error- defaults loaded'?
This error indicates the checksum of CMOS is incorrect, so the system loads the default equipment configuration. This may indicate that CMOS has become corrupt or that the battery is weak. Check the battery and replace it if necessary.
Why does my Acer Veriton 2800 say 'BIOS ROM checksum error - System halted'?
This error means the checksum of the BIOS code in the BIOS chip is incorrect, indicating the BIOS code may have become corrupt. Contact your system dealer to replace the BIOS.
What to do if the CD/DVD-ROM drive on my Acer Veriton 2800 Desktop cannot load or eject?
Disconnect all cables from the CD/DVD-ROM drive except the power cable, then press the eject button to try to unload the disk.
What to do if the CD/DVD-ROM drive on my Acer Veriton 2800 Desktop does not read?
Ensure the CD/DVD-ROM driver is installed properly.
What to do if my Acer Veriton 2800 Desktop keyboard is locked out?
This message usually means that one or more keys have been pressed during the keyboard tests. Make sure no objects are resting on the keyboard.
What does 'Display switch is set incorrectly' mean on my Acer Desktop?
This message indicates the display switch on the motherboard is set to a different setting than indicated in Setup. Determine the correct setting, then either turn off the system and change the jumper, or enter Setup and change the Video selection.
General| Graphics | Integrated Intel Extreme Graphics 2 |
|---|---|
| Networking | Integrated 10/100 Ethernet |
| Processor | Intel Pentium 4 / Celeron |
| Operating System | Windows XP Professional |
| Audio | Integrated |
| Expansion Slots | 3 x PCI |
| Optical Drive | DVD-ROM or CD-RW/DVD-ROM Combo |
| Weight | Approx. 22 lbs (10 kg) |
