Step 8:
At least select two HDD as Menber Hard Drive(s).
Picture13
Step 9:
Specify Volume Size then press "next".
Step 10:
Press "next" to finish setup and start create RAID5.
Step 11:
It may takes half and hours to create RAID5.After create completely,it will ask to
reboot to finish create RAID5.
2-4:Create a“RAID Ready” System into" RAID 10" with three Hard Drives by‘Create RAID Volume
from Existing HDD Drive ’.
Step 1:
Install Vista OS with one SATA HDD.
Step 2:
Shut down the system,then add other two serial ATA hard drives in the system.
Step 3:
Boot to OS desktop, open the Intel® Matrix Storage Console.
Step 4:
Click on the by‘Create RAID Volume from Existing HDD Drive ’ to create a RAID
Step 5:
Click "Next" at create a RAID volume window.
Step 6:
Key the name in "Volume Name" and select "RAID 10" in RAID Level.
To Next Page
Loading...
