What does Virus-related error mean on Acer Desktop?
The BIOS has detected software attempting to write to a drive’s boot sector on your Acer Desktop. This is flagged as possible virus activity. This message will only be displayed if Virus Detection is enabled in AMIBIOS setup.
Why does my Acer Veriton Z290G show 'Drive Not Ready'?
The BIOS was unable to access the drive because it indicated it was not ready for data transfer on your Acer Desktop. This is often reported by drives when no media is present.
What does 'Boot Failure...' mean on Acer Veriton Z290G?
This is a generic message indicating that the BIOS could not boot from a particular device on your Acer Desktop. This message is usually followed by other information concerning the device.
What does A: Drive Error mean on Acer Veriton Z290G Desktop?
The BIOS attempted to configure the A: drive during POST, but was unable to properly configure the device on your Acer Desktop. This may be due to a bad cable or faulty diskette drive.
Why does my Acer Veriton Z290G Desktop say 'Invalid Boot Diskette'?
A diskette was found in the drive, but it is not configured as a bootable diskette on your Acer Desktop.
What to do if Acer Desktop says 'Insert BOOT diskette in A:'?
The BIOS attempted to boot from the A: drive, but could not find a proper boot diskette on your Acer Desktop. Reboot and Select the proper Boot device or Insert Boot Media in the selected Boot device. The BIOS could not find a bootable device in the system and/or the removable media drive does not contain media.
What causes Secondary Slave Hard Disk Error on Acer Desktop?
The IDE/ATAPI device configured as Secondary Slave could not be properly initialized by the BIOS on your Acer Desktop. This message is typically displayed when the BIOS is trying to detect and configure IDE/ATAPI devices in POST.
General| Form Factor | All-in-One |
|---|---|
| Audio | Integrated |
| Networking | Gigabit Ethernet |
| Ports | HDMI |
| Operating System | Windows 7 Professional |
| Optical Drive | DVD-RW |
To Next Page