41
1.1.3 Flash the code
Now click the “AUTO PROG” Button. After finished, the screen should look like this:
In the process of burning LED lamp will flashing red and green across
When you need writing other machine, only need connect ok and press “space key” it will automatic update the FW
don’t need close the software.
When you update the FW appear this error, please check:
1. If have power on
2. The tool connection if is OK,
3. The tool connecting cable red pin need connect together with 14 pin needle
4. If still can’t solve I, please replace a PC or replace a tool and try again.
5. Use windows 10 system 64 bit.
To Next Page
Loading...
