Check if there is any damage to the circuit of the color wheel motor drive board.
11. Gobo1/2 Reset Error
Check if the position of the gobo wheel1/2 mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the gobo wheel1/2 operating range.
Check if the gobo wheel1/2 Hall elements is damaged.
Check if the gobo wheel1/2 Hall elements is in poor contact with the lead of the PCB board or
disconnected.
Check if the gobo wheel1/2 motor is damaged.
Check if there is any damage to the circuit of the gobo wheel1/2 motor drive board.
12. R-Gobo1 Reset Error
Check if the position of the gobo wheel1 mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the gobo wheel1 operating range.
Check if the gobo wheel1 Hall elements is damaged.
Check if the gobo wheel1 Hall elements is in poor contact with the lead of the PCB board or
disconnected.
Check if the gobo wheel1 motor is damaged.
Check if there is any damage to the circuit of the gobo wheel1 motor drive board.
13. Blade Reset Error
Check if the position of the blade mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the blade operating range.
Check if the blade Hall elements is damaged.
Check if the blade Hall elements is in poor contact with the lead of the PCB board or disconnected.
Check if the blade motor is damaged.
Check if there is any damage to the circuit of the blade motor drive board.
14. Prism Reset Error
Check if the position of the Prism mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the Prism operating range.
Check if the Prism Hall elements is damaged.
Check if the Prism Hall elements is in poor contact with the lead of the PCB board or disconnected.
Check if the Prism motor is damaged.
Check if there is any damage to the circuit of the Prism motor drive board.
33C
To Next Page
Loading...
