ASSEMBLY
INSTRUCTIONS
ALL MODELS
PLEASE READ
COMPLETELY
BEFORE
YOU
ASSEMBLY.
For
assembly you
will
require a targe Phillips
type
screwdriver, and the small
attached
to
the interface cord.
2.
3.
4.
5.
5.
7.
Remove bases, speaker panels and interface from their packing cartons. To
the
of
the panels
for
assembly.
Using the small hex wrench provided, the disassemble the side plates from the main
assembly. Set the screws and wrench aside they
required
later.
Set a speaker base on the
floor.
nameplate
side
up. the side plates
on
the base as
shown
(1
securing them
two
slot
head
screws
per
plate.
Leave
Lay
speaker
GENTLY
on the
floor,
the wiring harness facing
up.
DO
NOT
DROP!
The frapped
air
under fhe panel can rupture fhe speaker diaphragm.
Have
a helper
raise
the
lower
end panel,
or
support
it
on the box.
the completed base assembly shown
aligning
the side plates
to
the in the speaker back panel. Tighten all screws securely.
Standing
the
compfeted speaker up vertically. position the interface assembly the
speakerasshown
(3).
Locate harnessemergingfromthe the
speaker panel. Separate the three wire bundles
into
the
with the plug on the
end: the
BLUE
group
With
the blue hook
on
end; and the
WHITE
gmup,
with
on the end.
Referring
to
diagram
insert pin plug
(RED
group) into the
RED
socket on circuit
board
of
the interface
Aff
ach
BLUE
hook
to
the on the right
side
the
blue
dot
the spacer
below
the thumbscrew, and the word
'BLUE'.
the
thumbscrewseveral
washerand tighten
Repeaf
this procedure
for
the
hook on fhe
side
of
the circuit board.
assemble the inferface
side
plates,
GENTLY
feeding the
wiring
back the hole
in
the speaker panel. on the side
plates. keeping
flanges on the
OUTSIDE
side
as
shown
(4)
&
(5).
the
four
head screws info fhe hofes in the sides inferface. and ttghfen
the
hex wrench provided
(5).
9.
Position
fhe assembled speaker systems
the
room,
two
or
three
from the
backwalland at
least
'SPEAKER
section
of
the
the cord
info
an wall
outlet.
speaker terminals to making sure that proper phasing
positive
(RED)
terminal
on
speaker
is
connected
to
(RED)
terminal
on
and
for
(BLACK)).
1411
B
INTERFACE
SYSTEM
GENTLY
layfhe woofer module on
its
side,
exposing the woofer cone and
left
and right terminal
connections
(6).
Connect the woofer on the the terminals labeled 'woofer' on
the back
of
the
speaker inferface. Repeat this procedure
for
the right
Be
sure
proper phasing
(see
section
on
phasing
in
the placement
section
of
the manual.)
4
To Next Page
Loading...