EasyManua.ls Logo

ACR Electronics BIVY STICK - Fcc Information

ACR Electronics BIVY STICK
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
broadband network operating close to the frequencies used
by any global Navigation Satellite system (GNSS), Such as the
Global Positioning Service (GPS). Use of such devices may
impair reception of GNSS signals.
The Bivy Stick is a mobile transmitter and receiver that uses
an internal antenna to send and receive low levels of radio
frequency energy for data communications. The device emits
RF energy below the published limits when operating in its
maximum output power mode. To comply with RF exposure
compliance requirements, the device should be a minimum
of 20cm between the device and your body during operation.
The device should not be used in other configurations. This
device must not be co-located or operated in conjunction
with any other transmitter or antenna.
DECLARATION OF CONFORMITY
Hereby, ACR Bivy declares that this product is in compliance
with the Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following Internet
address: www.acrartex.com
UK DECLARATION OF CONFORMITY
Hereby, ACR Bivy declares that this product is in compliance
with the relevant statutory requirements. The full text of the
declaration of conformity is available at the following Internet
address: www.acrartex.com
RADIO FREQUENCY RADIATION EXPOSURE
This device is a portable transmitter and receiver that uses
an internal antenna to send and receive low levels of radio
frequency (RF) energy for data communications. The device
emits RF energy below the published limits for portable use
when operating in its maximum output power mode and
when used with ACR Bivy authorized accessories. To comply
with RF exposure compliance requirements, the device should
be used as described in the manual. The device should not be
used in other configurations.
FCC INFORMATION
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
11