Need help?Do you have a question about the ACS DRIVESAFE and is the answer not in the manual?
General| Brand | ACS |
|---|---|
| Model | DRIVESAFE |
| Category | Test Equipment |
| Language | English |
Press the power button once to start the tester; the startup sequence will begin.
The tester is prepared for use, indicated by a READY message and green backlight.
Insert a new mouthpiece and blow steadily for 5 seconds; a tone confirms proper breath flow.
Occurs if a proper breath sample isn't provided; prompts re-testing.
Shows BrAC concentration digitally, with a bar graph and color backlight for interpretation.
The tester auto-powers down after inactivity; manual shutdown requires two quick button presses.
Verify plastic tab removal and battery condition to troubleshoot power issues.
Address by changing mouthpiece, checking calibration, or waiting after consumption.
Signifies calibration is due; contact a Service Centre for recalibration.
Replace the mouthpiece if it becomes clogged or dirty to ensure accurate testing.
Indicates low battery; replace the AA alkaline batteries.
Signal potential service needs during power-up; contact ACS for return procedures.
To Next Page
