ACS DRIVESAFE - Battery Power Management; Battery Strength Indicator; Battery Installation Guide

INSTRUCTION MANUAL10 DRIVESAFE 11
BATTERY POWER
The DRIVESAFE personal alcohol tester requires two AA
alkaline batteries for operation.
In production, a plastic tab is inserted between the
battery and the electrical connection to conserve battery
power during shipment and storage.
Tooperatethetesterforthersttime,pulltheplastictab
from the battery compartment, which is accessible at the
back of the tester.
The tester can perform over 1,000 tests with a set of new
batteries.
BATTERY STRENGTH INDICATOR
A battery strength indicator appears on the bottom right
corner of the display when the DRIVESAFE tester is
powered on. When the battery strength indicator begins
toash,thebatteriesrequirechanging.
If the E01 error message appears on the display, there is
insufcientpowertocontinueoperationofthetester.
BATTERY INSTALL
Turn off the tester before removing the batteries. To
install new batteries, remove the back battery cover by
pressing down on the indent and slide the cover
back.
