User Manual | Endo Dual | J28940 | V1 | 06/2018 | NO69EN080H
- The medical device is not designed to operate near a source of ionising radiation.
- Do not insert metallic objects into the medical device to avoid any risk of electric shock, short circuit or the emission of
hazardous substances.
Maintenance:
Before and after each use, it is imperative to disinfect your medical device with products recommended by the
manufacturer.
Before each intervention, it is imperative to use cleaned and disinfected accessories.
Accessories:
The medical device only accepts accessories designed by the manufacturer, and only for the use for which they were
intended.
The use of accessories from another source could put you or your patients at risk.
Repair:
Do not carry out any repairs or modications of the medical device without prior authorization from the manufacturer.
In the event of an anomaly, contact the supplier of your medical device. Do not use any repairer that could make your
medical device unsafe for you and your patients.
The pre-programmed modes of the endodontic motor are programmed for Satelec les in rotation and reciprocation; and
Satelec les are suitable for working with these parameters.
When using drills, cutters or other endodontic accessories, follow the manufacturer's recommendations for maximum
speed, torque, angle or forward and reverse directions.
4 - DESCRIPTION
4.1 PHYSICAL DESCRIPTION
- Electronic control console with MOTOR mount
- Footswitch
- Power
To Next Page